|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Spec stage 3+ problems
|
|
02-18-2019, 08:09 AM | #1 |
First Lieutenant
45
Rep 390
Posts |
Spec stage 3+ problems
Hi guys
I have recently installed a stage 3+ clutch, single mass flywheel with the provided throw out bearing. The bearing is now screaming after just 50 miles, has anyone else encountered something similar? Am I looking at pulling the box out again to replace the new bearing? Thanks Adam
__________________
2007 E92 335i, JB4 + custom back end flash, DCI, Downpipes, FMIC, Silicone inlets, Pure Stage 2 High Flow Turbos, Spec Stage 3+ Clutch and Single Mass Flywheel,
|
02-18-2019, 08:22 AM | #2 | |
Joint Chiefs of Staff
4912
Rep 115,980
Posts |
Quote:
I haven't come across that before and we have lots and lots of customers running that clutch. Is it possible something wasn't put together properly? Mike |
|
Appreciate
0
|
02-18-2019, 08:26 AM | #3 |
First Lieutenant
45
Rep 390
Posts |
Thanks for the quick response Mike,
I have emailed spec this morning and just waiting to see what they say. Anything is a possibility but I doubt it, if I rest my foot on the clutch pedal the screaming stops. After searching google it seems quite common on other platforms for people to throw the bearing the spec provide in the bin and run a new genuine bearing in. |
Appreciate
0
|
02-18-2019, 01:56 PM | #4 | |
First Lieutenant
98
Rep 300
Posts |
Quote:
__________________
"Wheels and exhaust aren't a build"
|
|
Appreciate
0
|
02-18-2019, 02:36 PM | #5 |
First Lieutenant
45
Rep 390
Posts |
Had an email back from spec.
They’ve never heard of the throw out bearing failure and they can’t send me a replacement without me sending the old one back. Think I’m just going to cut my loses and fit a new genuine bearing. I hope their clutches are better than their bearings! |
Appreciate
0
|
Bookmarks |
|
|