|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
What size washer for front turbo actuator adjustment
|
|
02-18-2019, 08:31 PM | #1 |
Lieutenant
93
Rep 541
Posts |
What size washer for front turbo actuator adjustment
Can someone advise me on the washer size needed to use the "washer" method to adjust my front turbo?
I replaced my rear actuator arm, and i have no more 30ff codes, however when I look at my logs (i am bone stock) my WGDC hangs at 100% and I believe I may still have some boost leaking (probably from the front turbo). |
02-19-2019, 07:29 AM | #2 |
Captain
201
Rep 713
Posts |
I am also interested in this question.
I read that most people who did the washer method, used 2 standard 8mm spacers on both screw, so 4 spacers in total. I think the thickness of a spacer is something like 1mm to 1.4mm or something. The best thing is probably to try with 2 spacers. |
Appreciate
0
|
02-19-2019, 11:47 AM | #3 | ||
Major General
4276
Rep 9,206
Posts |
Quote:
Quote:
|
||
Appreciate
1
studio54201.00 |
02-19-2019, 03:49 PM | #4 | |
Lieutenant
93
Rep 541
Posts |
Quote:
My plan is to get a bunch of washers, put them in, and go until my front wastegate shuts at 5.9HG. When i adjusted my rear i tested the front and it seemed to do a partial close around 6HG and full close around 7HG. |
|
Appreciate
0
|
Bookmarks |
|
|