|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Vanos sensor
|
|
10-07-2011, 06:21 PM | #1 |
Captain
224
Rep 699
Posts |
Vanos sensor
My vanos sensors are going out and i looked at tischer's site but they only have it labeled "Control valve solenoid", I need both the Intake and Exhaust solenoids. My question is are they the same, do i order two of the Vanos solenoids?
http://www.trademotion.com/partlocat...&siteid=214672
__________________
2021 M2C HS DCT
2007 Wedge 335i E92 FBO, Stage 2 LPFP,VTT STG 2+, VTT Shotgun E50 w/ Inlets MT-SOLD |
10-07-2011, 09:15 PM | #2 |
First Lieutenant
21
Rep 364
Posts |
They are the identical. Before you order the new ones, try cleaning them first using a spray cleaner and switching them around i.e. exhaust to intake and vice versa. I learned that from Eninty in this forum (thanks go to him for that).
|
Appreciate
0
|
10-08-2011, 05:13 AM | #3 |
Captain
224
Rep 699
Posts |
tried cleaning them and even sea foamed them but still causing problems. I also noticed my car has been smoking a lot through the exhaust and I'm assuming thats being caused by the solenoids but idk
__________________
2021 M2C HS DCT
2007 Wedge 335i E92 FBO, Stage 2 LPFP,VTT STG 2+, VTT Shotgun E50 w/ Inlets MT-SOLD |
Appreciate
0
|
10-08-2011, 05:46 AM | #4 |
Major
160
Rep 1,307
Posts |
From what I read, if you have bad VANOS solenoids and go WOT, it will give check engine light. Or get a BT Tool to scan for codes. You might want to pinpoint the problem before spending $200 on these parts. Yes the two solenoids are same.
http://realoem.com/bmw/showparts.do?...67&hg=11&fg=15 |
Appreciate
0
|
10-08-2011, 09:45 AM | #5 |
Captain
224
Rep 699
Posts |
i already got the codes, and I've been experiencing the check engine light and SES light, its just my car is also producing a lot of smoke so I'm wondering if thats the VANOS sensors.
__________________
2021 M2C HS DCT
2007 Wedge 335i E92 FBO, Stage 2 LPFP,VTT STG 2+, VTT Shotgun E50 w/ Inlets MT-SOLD |
Appreciate
0
|
10-08-2011, 12:14 PM | #7 |
First Lieutenant
21
Rep 364
Posts |
What exactly were the codes?
Perhaps there are three possibilities- vanos solenoids gone bad since you already tried cleaning and swapping, camshaft sensor itself or fuse in the engine electronics box. |
Appreciate
0
|
10-09-2011, 05:48 AM | #8 |
Captain
224
Rep 699
Posts |
Well they're going out because I'm pushing more hp than stock and its wearing down the solenoids. I don't think i can get them replaced by BMW because the code rarely appears
__________________
2021 M2C HS DCT
2007 Wedge 335i E92 FBO, Stage 2 LPFP,VTT STG 2+, VTT Shotgun E50 w/ Inlets MT-SOLD |
Appreciate
0
|
10-09-2011, 05:53 AM | #9 |
Banned
127
Rep 6,773
Posts |
They cost $100..i would just err on the side of caution and replace...as opposed to cleaning
Part #11367585425 http://www.bmwpartscenter.net/partlo...&siteid=215996 |
Appreciate
0
|
10-09-2011, 07:03 AM | #10 |
Slow,fast,slow, then you die.
12
Rep 243
Posts |
Just went through a nightmare with mr. VANOS. I suspected correctly it was worse. In the end dealer performed oil change, both VANOS replaced, cam ledges replaced, and cleaned carbon build up. I then replaced the plugs since they didnt think it was necessary. All of this until codes stopped occurring good luck and I hope it is only VANOS.
|
Appreciate
0
|
Bookmarks |
|
|