|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
ista configuration C: ? D: ?
|
|
02-25-2020, 06:00 AM | #1 |
Registered
0
Rep 3
Posts |
ista configuration C: ? D: ?
hello
(sorry for my English) I have installed ista 4.19, it works perfectly with windows 10. but I have not tested it on my car ( Enet Cable X3 F25). The doubt I have, is : my hard disk C: is full ! I installed on my second internal hard disk D: ista and ediabas. as I wrote above ista works normally on windows 10, is this, when I will connect to the vehicle, everything will work ? No worries with ediabas installed under D: ? thank you |
02-25-2020, 11:48 AM | #3 |
Registered
0
Rep 3
Posts |
Thank you very much.
As mentioned above, I use an ENET cable, ista works under windows. What is the use of BLP (1go) and SDP (128Go) ? I decompress them in Rheingold ? it seems that it is necessary for ista ? |
Appreciate
0
|
02-25-2020, 03:47 PM | #4 |
Brigadier General
3058
Rep 3,909
Posts |
I'm not sure. I don't understand where all the files need to go, etc. I think SDP must be all the daten files, though I can't remember exactly what they're needed for either.
|
Appreciate
0
|
02-25-2020, 05:13 PM | #5 | |
Registered
0
Rep 3
Posts |
I found the answer!
I use an enet cable, I don't need BLP and SDP. Quote:
https://diagnose-software.myshopify....on-instruction |
|
Appreciate
0
|
Bookmarks |
|
|