|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Pioneer AVIC z110bt compatible with my logic7 set up
|
|
11-25-2009, 09:34 PM | #1 |
Lieutenant
39
Rep 517
Posts |
Pioneer AVIC z110bt compatible with my logic7 set up
hey everyone,
i am looking to install my avic z110bt, i've heard that my logic7 uses optical cabling. can anyone let me know how i can make this work? i've heard all i need to do is replace the amp but any further informaiton would be greatly greatly appreciated! thanks, |
11-25-2009, 10:12 PM | #2 |
Brigadier General
289
Rep 3,201
Posts |
The audio into the Logic 7 amp uses a proprietary optical network called MOST. There is no known adaptor to run aftermarket HU INTO the MOST network.
The short answer is, if you want that HU in your Logic 7 system, you can't get there from here. The long answer is, you can bypass the Logic 7 amp and install your own amp, driving your own speakers. If you have ACCESS it will be disabled. Retaining the OE HU is important to avoid certain trouble codes, but I don't know how far you can get while keeping that optical cable plugged in. Might not be needed, might only need power/ground/CAN. |
Appreciate
0
|
11-26-2009, 11:01 AM | #3 |
Lieutenant
39
Rep 517
Posts |
thanks for the information VP.
has anyone else done this on the forum? i don't mind replacing the amp, but ALSO replacing 13 speakers....i would like to avoid this if i can. can anyone else chime in here? |
Appreciate
0
|
11-27-2009, 02:41 PM | #4 |
Brigadier General
289
Rep 3,201
Posts |
To answer your PM, your amp in the L7 system is really a Lexicon audio processor with a BMW-preprogrammed equalization curve, and an amplifier with active crossover filters and 9 channels of output:
Center (highpass or bandpass crossover) L front (highpass) R front R rear (highpass) L rear R rear effects (high- or bandpass) L rear effects L and R woofers (lowpass) There aren't any 9-channel aftermarket amps. The amps on the aftermarket don't neccesarily have the right crossover complement, and really don't have the BMW preset EQ curve, so your Logic 7 speakers will probably not sound "right". What you're trying to do is fit a round peg into a square hole. |
Appreciate
0
|
Bookmarks |
|
|