|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
328i Automatic input shaft seal
|
|
05-25-2022, 06:07 AM | #1 |
New Member
32
Rep 28
Posts |
328i Automatic input shaft seal
I am so close to being ready to drop the newer set up into the car and while I have the motor and transmission separated I wanted to change the input shaft seal that's located behind the torque converter. Upon closer inspection, am I able to remove this seal like any other normal seal or do I need to remove the bell housing?
The reason I ask is because it looks like its pressed in from behind but I find that odd so I'm not 100% sure. I looked up videos on YouTube but could only find a older model and it didn't look similar. |
Bookmarks |
|
|