|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
02 sensor code after dp install
|
|
06-24-2014, 05:02 PM | #1 |
New Member
0
Rep 5
Posts |
02 sensor code after dp install
I have an 07 335i my cobb access port reads P2C9E "Lambda sensor heating the catalyst 1, triggering" it then goes on to say that this is typically caused by a failing 02 sensor.
This code started when I got the four bolts connecting the downpipe to the rest off the exhaust blown off with a torch so i thought it was just caused by the exhaust leak made thereafter. I drove my car home slowly less than a mile from the shop that blew the bolts off for me. I then installed my new AA dp and the code is still there even after clearing it. Do I have a bad 02 sensor or could it be something else? And if it is an 02 sensor how should I go about figuring out which one it is? |
Bookmarks |
|
|