[firasbest]

hi everyone i tried to make my drl with angel eyes today on my 2011 e90 with frm v2 c08
so i made the follow change
VERHALTEN_DRL_TFL set to drl_s instead of drl_tfl_off
and recoded it
previously i have low beam as drl in auto position
now it gone and no angel eyes as drl in 0 position
and angel eyes in postion light flirk only with engine running
i didn't figure out the problem that happened
thanks in advance

[6ixSpd]

There's a few other lines that need to be changed too if I recall. Search with NCSDummy for more DRL parameters.

[LMB335IS]

You'll need to leave the headlight switch in the auto position. Change TAGFAHRLICHT_ECE_1 --> aktiv and DRL_TFL_MIT_SML --> aktiv as well. See if that does the trick.

[firasbest]

i will try this but first i need to fix problem of the led angel eyes flickering when engine is runing it seems like the voltage is too low
is there any methode to reset configuration to original state
i tried with the backup file that i made before but no luck
by the way car is european spec with halogen headlights

[LMB335IS]

Originally Posted by firasbest

i will try this but first i need to fix problem of the led angel eyes flickering when engine is runing it seems like the voltage is too low
is there any methode to reset configuration to original state
i tried with the backup file that i made before but no luck
by the way car is european spec with halogen headlights

Use expertmode profile (non coding profile) and go through the same first few steps up to reading the FRM module and closing the nettodat pop up. Once you've done that, change job to SG_CODERIEN (if it isn't already) and run job. The module will be default coded back to factory settings based on your VO.

[firasbest]

thanks i will try