|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
J Audio xd600/6v2 and JL Audio 600/1v2 crossover settings
|
|
06-08-2015, 08:24 PM | #1 |
cvsnowboarder
12
Rep 128
Posts |
J Audio xd600/6v2 and JL Audio 600/1v2 crossover settings
Hi everyone,
first off I have a 335i e93 with HIFI. I finally had my system installed. I am not happy with the sound. I would like to know where to set the crossovers and gains on the amps. My system consists of a JL Audio xd600/6v2 running 4" Helix Match components in front doors on ch.1/2 ......OEM components in rear on ch.3/4......Eartquake SWS8xi 2ohm. 8" subs under the front seats on ch.5/6 ( Technic Harness) ..... In trunk I have a sealed 10" Kicker COMP RT 4 ohm. box driven by a jl audio XD600/1v2......Until I replace the under seat Earthquake subs with Jehnerts how should I adjust the crossover and gains on these amps to get the best possible sound? Thanks, Genna |
06-08-2015, 09:28 PM | #2 |
Lieutenant General
1911
Rep 13,104
Posts |
Showing a picture of your amp setting or listing them
Showing a picture of your amp setting or listing them might be a good thing to
do. A frequency of around 200 to 180 is good for most speaker combo's as a starting point with hardly any gain on the front doors and none on the rears and about 10 or 11 o-clock on the underseat gain is and average setting. If you bought the 2 ohm underseats the gain might be less. Do you have the high pass and low pass switches in the right position. You need someone with SWS to chime in on this. Also were there any setting on the door crossover between the tweeters and 4 inchers. http://www.e90post.com/forums/showthread.php?t=1135360 If you are going to adjust stuff mark where you started from so you can get back to it by putting some masking tape and hash marks on it. Last edited by ctuna; 06-08-2015 at 09:56 PM.. |
Appreciate
0
|
06-09-2015, 07:04 PM | #3 |
cvsnowboarder
12
Rep 128
Posts |
Thanks for the advice. I would upload pics of my amps but I can't figure out how to do it on here yet. To answer your question as to what the crossovers are set at, I really don't know. I'll have to call my installer and ask him. I feel that the tweeters aren't bright enough though.
|
Appreciate
0
|
06-09-2015, 07:45 PM | #4 |
Lieutenant General
1911
Rep 13,104
Posts |
The crossovers for the tweeters genraly are adjustable
The crossovers for the tweeters generally are adjustable
via jumpers but the setting are limited. Does the installer have expierence with these cars? Go to the advanced setting on your pc and select the photo you want and download it. I guess the match crossover has no adjustment upon looking more closely . Last edited by ctuna; 06-09-2015 at 07:58 PM.. |
Appreciate
0
|
Bookmarks |
|
|