[Luper52]

Been following a generally OEM route with the additional upgrade that I feel is well integrated and up to spec or equivalent to BMW quality. This post is specifically to show off the new VMR v703 or VB3 19 inch wheels.

Front: 19x8.5 ET40
Continental ExtremeContact DWS06 Plus 245/35R19
5mm spacer

Rear: 19x10 ET33
Continental ExtremeContact DWS06 Plus 275/30R19
10mm spacer

Currently rubs in the rear on any dips or medium-small bumps in road, partially due to the rear shocks needing to be replaced, especially on the driver's side. I will be ordering both a 7.5mm and 5mm spacer to figure out the best option.

In the meantime, enjoy the pics!

[Tambohamilton]

Nice bike.

You'll want hubcentric spacers there, otherwise you're almost guaranteed vibration...good luck with that

[Luper52]

Originally Posted by Tambohamilton

Nice bike.

You'll want hubcentric spacers there, otherwise you're almost guaranteed vibration...good luck with that

Thanks! Worked out that it was white and so was my car.

Hard to do with anything below a 10mm spacer because there's not enough space to make a lip. The 5mm on the front is doing fine with no noise so worst case scenario if a 7.5mm is so big that it vibrates then I'll just run both a 5mm in the rear and front.

[Tambohamilton]

True, at 5mm it should be small enough for the wheel to still catch the hub spigot