[mike5124]

Originally Posted by cheerio

That all sounds pretty reasonable, and if it overwrites your tune, not a big deal, you can always reflash it.

I used a generic cable, but I had to flash the fixed firmware to it in order to flash the EGS. Bimmergeeks cable comes with this firmware already flashed, so would work fine.

Hi, I'm curious about where you grabbed that fixed firmware and how to flash it. TIA!

[cheerio]

Originally Posted by mike5124

Hi, I'm curious about where you grabbed that fixed firmware and how to flash it. TIA!

https://github.com/uholeschak/ediaba...CAN_adapter.md
I just followed Step 2 from the above link.
I didn’t have a dedicated AVR programmer, but you can use an Arduino as one.

[deepakita]

hi cheerio !
I've been running my 323i with 325i DME file using the edited bin file provided by you in the #1 post of this thread.
However now I'm trying to figure out the way to update the 325i map from S8608465 to S8608689, struggling to figure out where to over write the powerclass on the 325i file.

It was also mentioned in the first post that "Found what seems to be the powerclass byte at 0x2191; in 323i it's 0, 328i 1, and 325i/330i both 2.", but couldn't find the exact address that matched to what's mentioned above.

Got any clues about how to work on those bin files? Any input from you would be appreciated, thanks!
-deepakita