[EvoScorp]

Hello, I am new to coding and just performed an iDrive/Combox retrofit on my non-iDrive 2009 E90 335i. All went well and most stuff works except my navigation from what I can see.

I need coding done and either want to find someone who offers the service to code it all or find a reputable place to download NCS-Expert and INPA if that if that is what I need in order to do the coding myself.

I have heard a lot about a guy Nick, but don't seem to be able to get a hold of him on emails I have seen on YouTube vids where he had performed the coding.

I did find a site called NCS-Expert.com but wasn't sure if this was legit or a scam and if it is legit, what all I would need to purchase/download to fit what I am needing done.

Does anyone have any information to either of these? I thank you in advance for your time and am looking forward to your replies. Thank you.

[EvoScorp]

Can anyone help?

[LMB335IS]

DM me, I can get you a good free copy of BMW Standard Tools 2.12.

[BRG_N54]

Originally Posted by EvoScorp

Hello, I am new to coding and just performed an iDrive/Combox retrofit on my non-iDrive 2009 E90 335i. All went well and most stuff works except my navigation from what I can see.

You will need much more to get the navigation working than just those programs, in fact neither of those will do anything to enable navigation. I suggest you start by looking at this thread, under the section "unlocking navigation".

If you determine you have a C1A CIC unit and want to proceed, I have a thread here with two of the downloads you will need. You will also need Jaeger's code generator for use with the 1B file you extract with your USB stick.

Best of luck, it may be less headache to just find someone to remote code it for you. But it will still need to be C1A firmware in your CIC for either solution to work.