|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Christmas came early for me - ABS codes
|
|
11-30-2023, 11:03 AM | #1 |
Registered
0
Rep 4
Posts |
Christmas came early for me - ABS codes
Hey, when crusing on the highway I got this beatiful sight, with cruise control & speedometer not working:
The codes are all related to wheel speed sensors, the question is, should I also replace rear wheel bearings & ABS rings? Weird thing is that when I left the car sitting for one hour, everything was working after that - no lights on the dash.. So I'm honestly not sure if its just ABS sensors or something worse going on. Thanks for any help & advice. |
12-01-2023, 04:57 PM | #2 |
Registered
0
Rep 2
Posts |
i have the same issue and it also goes away pretty soon,my codes are for abs pump tho...but its not?
but my buddy just replaced the sensor and the ring and it was okay ,im goona try that first and if it doesnt work then i guess it is the pump..just makes no senske ,wouldnt the pump be always showing the lights .. |
Appreciate
0
|
12-06-2023, 06:54 PM | #4 |
Lieutenant Colonel
213
Rep 1,782
Posts |
I would just reset the codes though it mght take a few tries. Also if you're traction starts flashing which it might eventually, you'll have to put a washer on the wheel speed sensors. It's because rust forms underneath the reluctor ring that pushes it into the sensor. It can destroy the sensors when this happens.
__________________
Koni special active red, eibach pro-kit springs, Remus exhaust, stage 3 intake manifold,Stage 2 AA tune, BMW Short shift kit. Silicon intake pipe. M3 control arms front, M3 rear. ECS trailing arm with whiteline bushings. Purple powerflex subframe bushings. Yellow power flex upper shock mounts. Single mass flywheel OE weight.
|
Appreciate
0
|
Bookmarks |
|
|