[AaronHoloster]

Before I post this I search around and I can't find the the solution, so please help ... anyways My DSC Brake and ABS light is on,BT tools found DSC popped 3 code:

1. 5DD2 DSC: Hydraulic unit: Calibration,DSC unit(valves)
2. 5DD0 DSC: Hydraulic unit: Calibration DSC unit.
3. 9520 DSC: Steering column switch center , multifunction

And yes my steering wheel button wasn't working, so I open up the steering cartridges found that the ribbon wire all tangle up. so I put a new one in now I got rid of the 3rd code but 5DD2 and 5DD0 remain the same?
I went ahead and clean the Steering angle sensor even though no code was shown. but problem still there....

No cruise control No signal , what could this be? ABS sensor? I bought another cable to used it on DIS and INPA can I use those cable to test the ABS sensor pulse width working properly?

Thank you

[AaronHoloster]

I don't have Active steering , so there shouldn't be a angle sensor on the steering rack correct? which mean I only have one steering angle sensor not two?

[wobbles1]

Originally Posted by AaronHoloster

Before I post this I search around and I can't find the the solution, so please help ... anyways My DSC Brake and ABS light is on,BT tools found DSC popped 3 code:

1. 5DD2 DSC: Hydraulic unit: Calibration,DSC unit(valves)
2. 5DD0 DSC: Hydraulic unit: Calibration DSC unit.
3. 9520 DSC: Steering column switch center , multifunction

And yes my steering wheel button wasn't working, so I open up the steering cartridges found that the ribbon wire all tangle up. so I put a new one in now I got rid of the 3rd code but 5DD2 and 5DD0 remain the same?
I went ahead and clean the Steering angle sensor even though no code was shown. but problem still there....

No cruise control No signal , what could this be? ABS sensor? I bought another cable to used it on DIS and INPA can I use those cable to test the ABS sensor pulse width working properly?

Thank you

YOU NEED TO RECALIBRATE YOUR DSC UNIT AND STEERING ANGLE SENSOR.

[AaronHoloster]

Would u mind to share the detail how it done I tried to calibrate the angle sensor with BT tools but the code still stored and how do I calibrate the dsc? I know there are 5 sensor internal how do I calibrate that ? Can I get it don't with inpa or DIS?

[AaronHoloster]

anyone?

[wobbles1]

steering angle sensor will not calibrate until the dsc has already been done.

[Black16]

Anyone?

[zigsman]

DIS should have a task to knock that out. I need to complete a calibration on my car this week as well.