|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Rear brake parts help
|
|
11-01-2011, 07:19 PM | #1 |
Senior Troll
224
Rep 3,378
Posts |
Rear brake parts help
Hi guys
I need to find a list of parts i need when i change the rear brake pads and disc for the 335i. I looked at realoem and its quite confusing on the diagram, would i need new protection plates? or inner hex box etc or would i need just the following these item with part number from bmwminipaarts.com Pads- 6775678 ,disc 6764655 and sensors 6762253? would it be the same if i gave these number to bmw parts department? thanks p.s has anyone seen a tutorial in here? i did a search but only mention pads and sensor. Thanks
__________________
Gone:
N54 335i is the Legend! N55 435i Now: 718 Cayman GTS / F83 M4 Last edited by AlanYoro35i; 11-01-2011 at 07:34 PM.. |
11-02-2011, 06:48 AM | #2 |
Second Lieutenant
22
Rep 235
Posts |
bud just go to euro car parts give them your reg and buy the following
2 new rear discs one set of good quality pads one rear brake pad wear sensor You can re use your existing anti rattle clip and the dsics wel come with a new locator nut for both sides. job done :-) If i recall i think its a 15mm bolt (maybe 14 i have forgotton) which holds the rear caliper carrier on so as long as you have a socket set and allen key socket set your good to go :-) its a DIY job. While the discs are off id adjust the handbrake shoes :-) Last edited by westsidee90; 11-02-2011 at 06:50 AM.. Reason: sala |
Appreciate
0
|
Bookmarks |
|
|