[Flex68]

ok peeps so i bought a ER charge pipe and the hose that came with it was way too short so i had to use the stock rubber cooler hose. When removing the one time hose clamp i put a small pin hole in the rubber hose ( not sure if that affects performance ) as i used a pick tool to get enough up to use a screw driver to remove the oem rubber hose.

so basically does anyone make a quality silicone replacement or know where i can get a replacement from???

[_ink]

It's just silicon hose, not not where you can get ribbed ones like those.

But if you measure the diameter, you should be able to search online for it.

[Flex68]

Originally Posted by _ink

It's just silicon hose, not not where you can get ribbed ones like those.

But if you measure the diameter, you should be able to search online for it.

sorry i meant this hose that attaches to the charge pipe

[_ink]

Even better! Go to an autobahn/repco/supercheap (take it off) and buy a turbosmart 45 degree hose that is long enough to fit..

I haven't been running that stock hose for ageeeeessssss.

Oh, and bring a blade so you can cut the hose.

[Flex68]

Originally Posted by _ink

Even better! Go to an autobahn/repco/supercheap (take it off) and buy a turbosmart 45 degree hose that is long enough to fit..

I haven't been running that stock hose for ageeeeessssss.

Oh, and bring a blade so you can cut the hose.

ok perfect so bascially a long enough 45 degree bend will be doable then . ACESS

[_ink]

Originally Posted by Flex68

ok perfect so bascially a long enough 45 degree bend will be doable then . ACESS

Totally!

[Flex68]

Originally Posted by _ink

Totally!

awesome. Cheers for that, will be stopping by autobarn tmw .