[Sasquatch101]

Recently purchased a 2008 335i and working through the codes
Previous posts focus on vehicles that won’t start w/ code 2ACC. Mine does, but I am assuming it is just a matter of time.
I have read that relay K6300 is likely opening for a number of reasons.
I am curious if anyone has used stabilant 22a on the connectors to JB A4010 and the ECM? Looking for proactive measures with the problem being intermittent.
Planning to replace the E-Box cooling fan while in there. That should fix code 2F71
I have also read that relay K6300 is solder on the Jbox fuse panel. Not going to change that when still intermittent.
The other code that is present is 2DEC. Hopefully that’s not the root cause.
Codes 2DEC and 2ACC popped up after replacing VANOS solenoids. I am pretty sure that is not related. It certainly cleared up a handful of codes.
Really curious if anyone has used stabilant with any success?
Thanks for your input.

[Spilt]

Originally Posted by Sasquatch101

Previous posts focus on vehicles that won’t start w/ code 2ACC. Mine does, but I am assuming it is just a matter of time.
The other code that is present is 2DEC. Hopefully that’s not the root cause.

Codes 2DEC and 2ACC popped up after replacing VANOS solenoids.

Hey there, I also had 2DEC and 2ACC pop up after jump starting the car when it died (also recently did thermostat, CKP sensor, tapped intake manifold vacuum)

Will this cause a no start? Did you find a fix? Thanks