|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
COAPI-2060: coding faulty
|
|
02-07-2021, 11:32 PM | #1 |
Enlisted Member
6
Rep 46
Posts |
COAPI-2060: coding faulty
I recently replaced the VGSG module (it got water damaged).
I flashed the software and set the VIN with WinKFP. Then tried to code it but given that it was the first time I was coding a module I'm not entirely sure I did everything right. I've been reading lots of online materials on how to properly use NCS Expert. No matter what I do now, I keep getting this "coding faulty" error. Tried to follow the steps to default code (select CAS, then change ECU to ABG, and run SG_CODIEREN) or to code it with a MAN file and a profile with manipulation enabled. I always get the same error. Any help is greatly appreciated. The error in the log file is: ERROR! Modul: A_VGSG.IPS, Proc: Cod, LineNr: 502, ErrorNr: 2060 COAPI-2060: coding faulty (general) VGSG90, STEUERN_FUNKTIONSPRUEFUNG: ERROR_ECU_CONDITIONS_NOT_CORRECT_OR_REQUEST_SEQUEN CE_ERROR >> ERROR! Modul: COAPI2.CPP, Proc: coapiRunCabd, LineNr: 06, ErrorNr: 2060 SG_CODIEREN My VGSG module is also throwing codes that say that my coding is faulty. |
02-08-2021, 11:26 AM | #2 | |
Lieutenant
532
Rep 432
Posts |
Quote:
https://www.loadstarsensors.com/asse...ncy-timer.html |
|
Appreciate
0
|
02-09-2021, 11:00 PM | #3 | |
Enlisted Member
6
Rep 46
Posts |
Quote:
|
|
Appreciate
0
|
Bookmarks |
|
|