Passenger Xeon not working right

theoforest · 08-16-2022, 10:34 AM

Hi everyone!

I have a e90 2007 and I got some headlight problem. I have the pre-lci adaptive xenon.

My passenger side xenon doesn't stay on, it keep turning off. Its not my headlight cuz it happen on my driver side headlight if I swap it. I haven't found a lot info on internet.
Ive tested ground on passenger side and I looked ok, check the wire on the headlight connector and they looked ok too exept 6 wich show copper but it's for the Xeon shutter (I think?)
Any input will be appreciate,

Thank you!

Serf27 · 08-16-2022, 10:37 AM

Bad bulb or bad bulb ballast.

theoforest · 08-16-2022, 01:09 PM

Quote:

Originally Posted by Serf27

Bad bulb or bad bulb ballast.

Forgot to mention, swapped everything including the whole headlight assembly and it stays on passenger side. I'm guessing some problem with the wiring or FRM but I can't find any info on How to test if

Serf27 · 08-16-2022, 01:42 PM

Your passenger headlight works if you plug it into the driver side connector?

theoforest · 08-16-2022, 01:53 PM

Quote:

Originally Posted by Serf27

Your passenger headlight works if you plug it into the driver side connector?

Yes I bought another set cuz I though the whole thing was dead. So my 4 headlight works driver side and they don't psssenger
Is there a way I can send a video ?

Serf27 · 08-16-2022, 06:41 PM

Does anything happen on the passenger side?
Xenon flickers? Or the bulb doesn’t turn on at all?

theoforest · 08-16-2022, 07:00 PM

Quote:

Originally Posted by Serf27

Does anything happen on the passenger side?
Xenon flickers? Or the bulb doesn’t turn on at all?

It ~flickers
Stays on for ~5 sec then turn off for ~5 sec and repeat

Serf27 · 08-16-2022, 07:09 PM

Odd. I was going to suggest reseting the frm short circuits, but it must be getting intermittent power.

Any changes if you wiggle the headlight wire loom?

theoforest · 08-16-2022, 07:17 PM

Quote:

Originally Posted by Serf27

Odd. I was going to suggest reseting the frm short circuits, but it must be getting intermittent power.

Any changes if you wiggle the headlight wire loom?

I tried wiggling it to see if there's some connection that doesn't make it but it doesn't changed anything. There my cable #6 on the connector that is cracked and show copper but It's for the Xeon shutter so it shouldn't affect. (I think ?)

theoforest · 08-18-2022, 04:04 PM

Anyone?

Serf27 · 08-18-2022, 06:45 PM

If you remove the tape from the harness, is there any other cracked wires with missing insulation?
How does the pigtail connector look on the inside?

theoforest · 08-19-2022, 10:47 AM

Quote:

Originally Posted by Serf27

If you remove the tape from the harness, is there any other cracked wires with missing insulation?
How does the pigtail connector look on the inside?

I found some exposed copper from the ground that I put electric tape on. Seems to stay on longer (or placebo?) but still turn off after a few seconds. I noticed my #3 wire on the connector can just pull out of the connector. I think it's the low beam xenon wich is what I'm having problem with. I guess I'll have to buy another connector

Serf27 · 08-19-2022, 01:06 PM

Plug the light into the connector and hold that loose wire in its place and see if the light stays on.

Those pins have some sort of dang that can usually be bent back into position so the pin stays inside the connector.

They also sell the pins by themselves, so you can repair that single pin instead of splicing in a whole new connector. Use some electrical cleaners on the connector too.

theoforest · 08-19-2022, 03:53 PM

Quote:

Originally Posted by Serf27

Plug the light into the connector and hold that loose wire in its place and see if the light stays on.

Those pins have some sort of dang that can usually be bent back into position so the pin stays inside the connector.

They also sell the pins by themselves, so you can repair that single pin instead of splicing in a whole new connector. Use some electrical cleaners on the connector too.

I held it and it seems to work fine but I went to turn on my car and move my steering wheel and it goes off sometimes. There other wire that are cracked, should I replace the whole connector ?
Do you know the parts number for the connector pin ?

Serf27 · 08-19-2022, 04:30 PM

Yea, if it’s barely being held in there, any slight movement could knock it out of place.

Serf27 · 08-19-2022, 04:36 PM

CITALL 12 Pin Headlight Plug Wiring Harness Pigtail Connector Fit for BMW F01 F02 E63 E64 E90 61132359991 https://a.co/d/2K7TfRV

https://m.aliexpress.com/item/325680...site4itemAdapt

https://www.fcpeuro.com/products/bmw...hoCoUQQAvD_BwE

The fcpeuro might be the best option.

theoforest · 08-19-2022, 05:34 PM

Quote:

Originally Posted by Serf27

CITALL 12 Pin Headlight Plug Wiring Harness Pigtail Connector Fit for BMW F01 F02 E63 E64 E90 61132359991 https://a.co/d/2K7TfRV

https://m.aliexpress.com/item/325680...site4itemAdapt

https://www.fcpeuro.com/products/bmw...hoCoUQQAvD_BwE

The fcpeuro might be the best option.

Thank you!
I'll take a look.
Pre-LCI and LCI are thé same connector ?

Serf27 · 08-19-2022, 06:17 PM

Same connector/pins.
Pin location within the connector is different.

theoforest · 08-19-2022, 08:58 PM

Quote:

Originally Posted by Serf27

Same connector/pins.
Pin location within the connector is different.

´ Okay good,
I'll do that soon
Thank you!

BB_cuda · 08-26-2022, 01:58 PM

Be careful when you pull the connector shell from that Passenger headlight. They are easily broken. Ask me how I know.

Not sure if you are changing the connector on the harness side or the housing side though. Please let me know how this comes out. I have large scale retrofit I've done and looking for anything I might have botched while inside the housings.

Good luck with the repair!

08-16-2022, 10:34 AM	#1
theoforest Enlisted Member 0 Rep 37 Posts Drives: Bmw e90 335xi 2007 Join Date: Jun 2022 Location: Montréal iTrader: (0) Garage List 2007 bmw 335xi [0.00]	Passenger Xeon not working right Hi everyone! I have a e90 2007 and I got some headlight problem. I have the pre-lci adaptive xenon. My passenger side xenon doesn't stay on, it keep turning off. Its not my headlight cuz it happen on my driver side headlight if I swap it. I haven't found a lot info on internet. Ive tested ground on passenger side and I looked ok, check the wire on the headlight connector and they looked ok too exept 6 wich show copper but it's for the Xeon shutter (I think?) Any input will be appreciate, Thank you!
	Appreciate 0 Tweet Quote

08-16-2022, 10:37 AM	#2
Serf27 Brigadier General 2851 Rep 4,322 Posts Drives: 335i Join Date: Apr 2018 Location: Sitting in a BMW. iTrader: (-1)	Bad bulb or bad bulb ballast.
	Appreciate 0 Quote

08-16-2022, 01:42 PM	#4
Serf27 Brigadier General 2851 Rep 4,322 Posts Drives: 335i Join Date: Apr 2018 Location: Sitting in a BMW. iTrader: (-1)	Your passenger headlight works if you plug it into the driver side connector?
	Appreciate 0 Quote

08-16-2022, 07:09 PM	#8
Serf27 Brigadier General 2851 Rep 4,322 Posts Drives: 335i Join Date: Apr 2018 Location: Sitting in a BMW. iTrader: (-1)	Odd. I was going to suggest reseting the frm short circuits, but it must be getting intermittent power. Any changes if you wiggle the headlight wire loom?
	Appreciate 0 Quote

08-18-2022, 04:04 PM	#10
theoforest Enlisted Member 0 Rep 37 Posts Drives: Bmw e90 335xi 2007 Join Date: Jun 2022 Location: Montréal iTrader: (0) Garage List 2007 bmw 335xi [0.00]	Anyone?
	Appreciate 0 Quote

08-16-2022, 06:41 PM	#6
Serf27 Brigadier General 2851 Rep 4,322 Posts Drives: 335i Join Date: Apr 2018 Location: Sitting in a BMW. iTrader: (-1)	Does anything happen on the passenger side? Xenon flickers? Or the bulb doesn’t turn on at all?
	Appreciate 0 Quote

08-18-2022, 06:45 PM	#11
Serf27 Brigadier General 2851 Rep 4,322 Posts Drives: 335i Join Date: Apr 2018 Location: Sitting in a BMW. iTrader: (-1)	If you remove the tape from the harness, is there any other cracked wires with missing insulation? How does the pigtail connector look on the inside?
	Appreciate 1 theoforest0.00 Quote

08-19-2022, 01:06 PM	#13
Serf27 Brigadier General 2851 Rep 4,322 Posts Drives: 335i Join Date: Apr 2018 Location: Sitting in a BMW. iTrader: (-1)	Plug the light into the connector and hold that loose wire in its place and see if the light stays on. Those pins have some sort of dang that can usually be bent back into position so the pin stays inside the connector. They also sell the pins by themselves, so you can repair that single pin instead of splicing in a whole new connector. Use some electrical cleaners on the connector too.
	Appreciate 0 Quote

08-19-2022, 04:30 PM	#15
Serf27 Brigadier General 2851 Rep 4,322 Posts Drives: 335i Join Date: Apr 2018 Location: Sitting in a BMW. iTrader: (-1)	Yea, if it’s barely being held in there, any slight movement could knock it out of place. Last edited by Serf27; 08-19-2022 at 04:36 PM..
	Appreciate 0 Quote

08-19-2022, 04:36 PM	#16
Serf27 Brigadier General 2851 Rep 4,322 Posts Drives: 335i Join Date: Apr 2018 Location: Sitting in a BMW. iTrader: (-1)	CITALL 12 Pin Headlight Plug Wiring Harness Pigtail Connector Fit for BMW F01 F02 E63 E64 E90 61132359991 https://a.co/d/2K7TfRV https://m.aliexpress.com/item/325680...site4itemAdapt https://www.fcpeuro.com/products/bmw...hoCoUQQAvD_BwE The fcpeuro might be the best option.
	Appreciate 0 Quote

08-19-2022, 06:17 PM	#18
Serf27 Brigadier General 2851 Rep 4,322 Posts Drives: 335i Join Date: Apr 2018 Location: Sitting in a BMW. iTrader: (-1)	Same connector/pins. Pin location within the connector is different.
	Appreciate 0 Quote

08-26-2022, 01:58 PM	#20
BB_cuda Brigadier General 765 Rep 3,556 Posts Drives: 2011 335D Msport, 2013 X5D Join Date: Nov 2011 Location: Clear Lake, Texas iTrader: (0)	Be careful when you pull the connector shell from that Passenger headlight. They are easily broken. Ask me how I know. Not sure if you are changing the connector on the harness side or the housing side though. Please let me know how this comes out. I have large scale retrofit I've done and looking for anything I might have botched while inside the housings. Good luck with the repair!
	Appreciate 0 Quote