[arc1880]

I just noticed this a couple of days ago after disabling one of the seatbelt handover/butler. I tried multiple settings and my car will no longer automatically lock when I drive off. I tried all the settings set through the cluster, but no luck. Any information would be appreciated. I did do a search but could not find any mention of the auto locking being disabled.

[Elliott@DetailAddict]

Strange. Mine works fine with them disabled.
I'd suggest restoring defaults to your modules and recoding.

[arc1880]

Originally Posted by Grant@DetailAddict

Strange. Mine works fine with them disabled.
I'd suggest restoring defaults to your modules and recoding.

Would you recommend that I do all of them or just the ones I have made code changes on?

[Elliott@DetailAddict]

Just the ones you changed.
Good place to start.

However... are you sure it didn't just turn the feature off?
Sometimes I have to go back into my iDrive (or customer's clusters if no iDrive) and just toggle it back on.

[Elliott@DetailAddict]

If you have iDrive its the "auto lock"
If no iDrive, its in you cluster settings and has an icon of a lock with a right arrow next to it.

[arc1880]

I am sure that I don't have it off. I've changed it to the different settings on the cluster (I don't have iDrive). But I will make sure to quadruple check again.

[cn555ic]

Grant is right as I also have coded about a dozen disabling the seatbelt handler and have never run into this issue. I would take his suggestion and code with expertmode and change all the default values back to stock, then code it again.