[7786]

BIMMERPOST / Classifieds

Asking Price:

Sold

Location:

✓ Will Ship

Item Interest

Selling my custom vent mounted gauge pod (gauge itself not included). This was specifically designed for the VEI systems V1 Radar gauge,
but should fit any other 52mm pod with similar dimensions (53.5mm diameter, 30mm until you hit the back brace). The back brace
has mounting holes for this specific gauge, so you'll have to figure out a different way to mount other gauges. Also there is no cap on the backside, so you'll have to find someway to cover that.

Couple of issues:
1.) The pod doesn't exactly face the driver, so you're viewing it at a slight angle (see pics).
2.) The front lip of the vent isn't flush with the dash, it sticks up about a mm (see pics).
3.) Vent grates are thinner than OEM

Selling this because I have ordered another piece with the above issues fixed.

Album with more pics:

View post on imgur.com

[7786]

Bump

[7786]

Up

[teknic90]

Damn. Like that gauge pod mount location. Where did you get it? I would grab this from you but I think the angle woukd drive me nuts too.

[7786]

Originally Posted by teknic90

Damn. Like that gauge pod mount location. Where did you get it? I would grab this from you but I think the angle woukd drive me nuts too.

I designed it, I'll make it available for purchase on my shapeways account once I test fit the new revision, hopefully later on in the week. It'll be roughly ~$70.

[teknic90]

Originally Posted by 7786

I designed it, I'll make it available for purchase on my shapeways account once I test fit the new revision, hopefully later on in the week. It'll be roughly ~$70.

Nice design. Looks really good. What's it made out of?

[7786]

Originally Posted by teknic90

Nice design. Looks really good. What's it made out of?

Thanks! It's printed from black nylon from shapeways. It's the same material I ended up using for my nexus 7 mount:

http://www.e90post.com/forums/showthread.php?t=1080830

[Route 16]

nice

[335iNavyGuy]

Originally Posted by 7786

Thanks! It's printed from black nylon from shapeways. It's the same material I ended up using for my nexus 7 mount:

http://www.e90post.com/forums/showthread.php?t=1080830

Hey man, I have a Robo R1 3d printer, mind giving me the plans for the mounts and such ?> I'll toss ya a few $$ for your time!

garyreen@gmail.com

lemme know thanks

[7786]

bump

[9krpmrx8]

Are you still making these? Link says it is still in development.

[7786]

Originally Posted by 9krpmrx8

Are you still making these? Link says it is still in development.

Hey, yeah you can still buy them from the link. I think they're pretty much done, it only says in development because I haven't gotten any feedback on them from those who purchased them. If you're interested PM your address and I can send you the one I took off my car when I sold it.