|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Coolant pump codes
|
|
03-25-2024, 12:49 AM | #1 |
New Member
2
Rep 8
Posts |
Coolant pump codes
The same thing has happened with my maf sensor where i replaced it and still got 2 codes. But this time its 2 coolant pump codes. 2E82 and 2E81 are the codes. I’ve replaced the water pump and thermostat since ive had the car and so far no over heating issues like it used to have. But I’ve noticed a light on the dash thats like a yellow snowflake light pop up and disappear some times. I have read the codes for the car a few times and ive nevrr cleared the codes should i try to clear the codes and re read them?
|
03-25-2024, 10:56 AM | #3 |
General
17315
Rep 18,737
Posts |
For any repair with codes and component replacement, always clear the codes FIRST, then disconnect the battery neg. terminal. Replace the part(s). Then reconnect the battery.
|
Appreciate
3
|
03-25-2024, 01:25 PM | #4 |
Registered
5
Rep 1
Posts |
As they said above always remove the old error codes and I should add an extra step, run the bleeding procedure to remove the air bubbles that you have in your system after the thermostat and coolant pump replacement, those can cause the issues you are facing.
Cheers |
Appreciate
3
|
03-25-2024, 11:57 PM | #5 |
New Member
2
Rep 8
Posts |
Thanks guys im going to read the codes and do those Procedures once it warms up in the next couple days. I have only installed the water pump, thermostat, maf sensor and a new battery but will clear the codes this time
|
Appreciate
0
|
Bookmarks |
|
|