![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
BMW Garage | BMW Meets | Register | Today's Posts | Search |
![]() |
![]() ![]() |
BMW 3-Series (E90 E92) Forum
>
CANBUS
![]() |
![]() |
03-22-2017, 05:54 PM | #26 |
Registered
0
Rep 2
Posts |
Hi,
I have managed to send the 0x130 (every 100ms) and 0x26E (every 200ms) messages to wake up the KOMBI. However, it is doing some kind of reset since it is continuously beeping and flashing error lights. In fact, when I send the RPM message of 1500RPM, the needle goes from 0 to 1500, back to 0 and again to 1500 repetitively. I am trying to make the KOMBI pretend that it is in a real car with its engine running i.e. displaying the time and odometer. Maybe the KOMBI is waiting for some specific messages other than the 0x130 and 0x26E. Does anyone have this problem, please? If yes, how did you managed to solve it, please? Thanks, Robert |
Appreciate
0
|
04-27-2022, 12:30 AM | #27 |
Biiimmer
![]() 3
Rep 15
Posts |
I'm going to skip to the end of these threads from now on.
Check if the last chapter was torn out. ![]() I'm always about 10 years too late to ask questions. Maybe I should buy a new BMW. |
Appreciate
0
|
![]() |
Bookmarks |
|
|