[Onizukachan]

Originally Posted by oVeRdOsE.

so few $$ question, what would be my best best for this code?

did a swap, the code wasn't there, now it's there.

What I did not plug back ?

abs sensor?

(transfer case is connected, both harness)

will get into it tomorrow morning.

You have to drive it on the ground (like around the block) so it can see the difference in abs sensors when turning. I’ve gotten that one twice when I left the doors open and ran the battery down.

[oVeRdOsE.]

Originally Posted by Onizukachan

You have to drive it on the ground (like around the block) so it can see the difference in abs sensors when turning. I’ve gotten that one twice when I left the doors open and ran the battery down.

every time I store the car, I remove the battery, and I have this.

But must be something else, it wont go away. I did not had time to check this yet.

Ill check wheel rotation with INPA, all 4 should read the same, if tires got same pressure.

Not impossible that a cable on the abs sensor internally broke.

Did not go to my alignment yet. soon. Hopefully by next week

[Onizukachan]

From what I read you have it up in the air, so all 4 turn at same speed. That is a fault, because they should all be turning at different speeds when you turn a corner/turn the wheel.


If the abs sensors all check out as good, go drive it around the block or drive a figure 8 or drive a circle clockwise and then counter clockwise.
That walkways cleared it x3 and on my e91 x.

Anytime it loses electrical power you will get the trifecta of lights. Mine usually clears after I back out of the driveway amd then turn left at the corner.

[oVeRdOsE.]

yep thats the plan.

I can do it in the street, I might not have all same reading, but let say if 1 is disconnected, Ill know right away.

[oVeRdOsE.]

some rubbers for the e91 and f25

[StradaRedlands]

Originally Posted by oVeRdOsE.

some rubbers for the e91 and f25

2.5 cars there!

[bmw335ie90]

Excuse the filthy engine bay....but installed an OEM performance strut brace. Shout out to NOKO for selling it to me.

Had to make an 1/8" spacer to lift the brace up as it rubbed on the top of the engine cover; these bars were meant for N52 cars.

[K9Leader]

Ordered new tires for my E91, because . . . well, this:



I had been feeling looseness and sliding in the rear the last couple of times I drove it so I pulled off the wheels to check suspension components and found the rears with severe inside wear. The fronts are also showing uneven wear on the insides, but nowhere near this bad. I'd had it aligned in December and am hoping that this uneven wear was from before the alignment, but I am surprised that the shop did not notice the wear and try to sell me new tires.

Anyway, new Continental DWS06+ tires. Then, get the alignment checked and sorted so it doesn't reoccur (and then better monitor tire wear).

[Onizukachan]

FYI that is almost always toe out.


Finally got the tools cleaning supplies, paints, etc etc mostly put away from everything I worked on over the winter and got the white mini (needs clutch) scooted over from the middle so I could finally get the e91 into the garage.

[Runnin'Rich]

You have two R53’s!
They are awesome especially the feeling of using the indicators!

[oVeRdOsE.]

Originally Posted by Onizukachan

From what I read you have it up in the air, so all 4 turn at same speed. That is a fault, because they should all be turning at different speeds when you turn a corner/turn the wheel.


If the abs sensors all check out as good, go drive it around the block or drive a figure 8 or drive a circle clockwise and then counter clockwise.
That walkways cleared it x3 and on my e91 x.

Anytime it loses electrical power you will get the trifecta of lights. Mine usually clears after I back out of the driveway amd then turn left at the corner.

- all wheels giving the same speed signal ...
- steering angle sensor is at 0° when steering is center and it read angle.

- all fault I have is absent module ; CA, sound system and car alarm. so nothing to do with the ABS .

- I have a transfer case code 5F3A, but seems like is related to my ABS issue


very strange

[K9Leader]

Originally Posted by Onizukachan

FYI that is almost always toe out.

Yes, the before report from the last alignment was:
LF 0.06 RF 0.09 Total Toe 0.16 Steer Ahead -0.02

LR -0.13 RR 0.10 Total Toe -0.03 Thrust Angle -0.11

After:
LF 0.05 RF 0.04 Total Toe 0.09 Steer Ahead 0.01

LR -0.07 RR 0.11 Total Toe 0.17 Thrust Angle -0.02

So, my bad for letting it be so out of alignment for long enough to ruin the tires - Michelin Pilot Sport A/S 3, five years old but with only 20k miles on them.

[PhaseP]

Originally Posted by oVeRdOsE.

- all wheels giving the same speed signal ...
- steering angle sensor is at 0° when steering is center and it read angle.

- all fault I have is absent module ; CA, sound system and car alarm. so nothing to do with the ABS .

- I have a transfer case code 5F3A, but seems like is related to my ABS issue


very strange

Each time battery is disconnected and reconnected, car always give that warning, at least mine does. To clear it you need to turn the steering wheel all the way to right and then all the way to left. It relearns the steering wheel limits. It is part of the ceremony of giving car electrical power back again.
If it is not clearing after turning the steering wheel all the way left and right, then you have some other problem.

[oVeRdOsE.]

Originally Posted by PhaseP

Each time battery is disconnected and reconnected, car always give that warning, at least mine does. To clear it you need to turn the steering wheel all the way to right and then all the way to left. It relearns the steering wheel limits. It is part of the ceremony of giving car electrical power back again.
If it is not clearing after turning the steering wheel all the way left and right, then you have some other problem.

yeah, I store my car during winter, so Im use to this.
However, this time it wont go away.

Ill do the alignment and if it's still there, Ill dig more.

I already had this issue with a very bad alignment back in the days. But the car was barely drivable, now it's very straight...

[NOKO]

Originally Posted by bmw335ie90

Excuse the filthy engine bay....but installed an OEM performance strut brace. Shout out to NOKO for selling it to me.

Had to make an 1/8" spacer to lift the brace up as it rubbed on the top of the engine cover; these bars were meant for N52 cars.

Looks killer brotha! Glad it went to a fellow enthusiast on the forums!