|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
n53 injector puller DIY for £5
|
|
02-09-2019, 01:47 PM | #1 |
Private
9
Rep 61
Posts |
n53 injector puller DIY for £5
I made one with parts from eBay and Amazon for about £5 using:
car wheel nut M12 x 1.5 bolt M12 x 1.5 and 120mm long (don't go shorter than this) ten steel repair washers M12 NB the M12 thread is a fine thread, if your nut isn't going on easily don't force it, you may have the wrong size. Given the low cost here I'd very much recommend having one on hand before you start an injector replacement job. Speaking from experience it's very frustrating taking all the engine covers off and then not being able to get the injectors out! photo here: https://flic.kr/p/2g8zSXB Last edited by OliSharp; 06-04-2019 at 07:22 AM.. Reason: update |
Bookmarks |
|
|