|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
P3 V1 (Rixster) Gauge Install DIY??
|
|
08-12-2014, 02:25 AM | #1 |
First Lieutenant
34
Rep 356
Posts |
P3 V1 (Rixster) Gauge Install DIY??
I am looking for the DIY for the Rixter/P3 V1 dash boost gauge. NOT the V2 or V3 the V1 which is the original model.
Got a BNIB set and need some help the instructions I have looked are all down and do not work. Also there was a new harness for 09 cars which has me even more confused. Tried calling and PMing Rixster no help. If anyone has any help/tip please let me know thanks |
08-12-2014, 06:17 AM | #2 |
I even mod my cereal
246
Rep 3,441
Posts
Drives: 11 ZCP DCT M3 14 328d 21 GT4
Join Date: Aug 2009
Location: Northern Va
|
It should be similar to the Ver 2 P3 vent gauge, with a few changes due to the CAN bus and such. But they obviously took down the older instructions because I could not find them either.
I do have a pdf of the Ver 1 install on my laptop at home so if you hit me up on the PM and give me your email address I can send it to you.
__________________
2011 Mineral White M3 ZCP - Opticoat, Ventureshield, some CF, B&B exhaust, AFE Intake Vorsteiner VFF 101s Ohlins
2014 Mineral White 328d Xdrive Wagon - Opticoat, Ventureshield, B8s, H&R, Apex SM-10s Hawk Pads 2021 718 Cayman GT4 - Fire extinguiser Last edited by bigdaddycane; 08-12-2014 at 06:24 AM.. |
Appreciate
0
|
Bookmarks |
|
|