|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
some help with errors please? 55c3, 55c6, 5E50
|
|
08-31-2021, 09:29 AM | #1 |
New Member
3
Rep 9
Posts |
some help with errors please? 55c3, 55c6, 5E50
Transmission
Fault memory 0055C3 Description: VGSG-wheel-naufregelung activated. no DXC target torque setting 0055C6 Description: CAN SIGNAL V WHL speed WHEEL CEh/Can message speed rad, ce Dynamic Stability Control (DSC) 009520 (SOS ERROR IF IM NOT MISTAKEN-LEAST OF MY WORRIES?) Description: Steering wheel MFL: mechanically defective, contact audio/telephone button for t> 5 min operated --- (DSC: switch cluster steering column: multifunction) / Steering wheel MFL: mechanically defective contact. / SSL: error entry for SSL: LWS error: audio/telephone switch: mechanical problem, contact. 005E50 Description: Wheel speed sensor front right: air gap too large. / Brake pedal error always active / Wheel speed sensor front right: air gap too large --- (DSC: wheel air gap front right) / F-CAN SSL serial number incorrectly Check Dynamic Stability Control (DSC) Changed the front right speed sensor- went into limp mode or shut downtransfer case or x drive, not sure if those are all the same things... Took sensor back off, added washer for gap, now too excessive, going back to smaller washer. Tried cleaning SAS (MY .02 CENT FIX ON E90POST.COM) now no error lights, just worse. Anyone have any ideas? Ordered new brake switch and abs sensor again. The reluctor ring doesn't look cracked or messed up except one small rub spot around the entire ring, still cleaned it anyway. Would transfer case fluid change be enough to help this? Am I missing something? I cannot seem to find any info about nominal torque setting... I'm at a loss. Any help would be greatly appreciated!
__________________
2007 BMW 328xi
|
09-04-2021, 11:34 PM | #3 | ||
New Member
3
Rep 9
Posts |
Quote:
Quote:
it was Bosch from FCPeuro. something funky happened today, driving home from work, 2e69 knock sensor signal 2 popped up by reducing speed. no check engine or dings from the car. could it be completely unrelated and randomly breaks while all of these other things are happening or could one of these previous issues be related? I have INPA but can't do much beside read and clear errors I believe I even have some other programs, but haven't figured those out yet, either.
__________________
2007 BMW 328xi
|
||
Appreciate
0
|
Bookmarks |
Thread Tools | Search this Thread |
|
|