|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Check engine light on, no codes from JB4
|
|
11-24-2018, 03:21 AM | #1 |
New Member
0
Rep 29
Posts |
Check engine light on, no codes from JB4
Hey everyone,
Picked up my car after quite a few mods done, did about 100ks then the orange engine light comes on. Read codes with JB4 but nothing is coming up aside from catless dp’s. Nothing on the CCC either. Any suggestions? Thanks in advance |
11-25-2018, 12:58 AM | #8 |
Lieutenant General
4542
Rep 11,903
Posts |
My bet is O2 sensors
|
Appreciate
0
|
11-25-2018, 03:19 AM | #9 |
New Member
0
Rep 29
Posts |
Big thanks to Ken Oath. Was good to meet you mate, I’ll be in touch for anything else that may crop up.
Yeah, the catless dps were the culprit, a dct fault too. The diff has been apart for an lsd install so maybe I have a faulty sensor? We cleared the codes using the jb4, I’ll investigate a bit further when it’s ready for a tune. |
Appreciate
0
|
Bookmarks |
|
|