|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
DCI install for $50
|
|
06-20-2018, 05:26 PM | #1 |
Private
16
Rep 53
Posts |
DCI install for $50
Hey All,
I know there are a million of these out there. I just wanted to share mine. I am not responsible for any damage you may cause performing this service. Tools: Flathead 1/4 inch bit bit-driver Arms I Purchased all my parts through Amazon: 2 x https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1 2 x https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1 1:Clean any residue off of the inside of your adapter pipes. I used alcohol and a clean rag for this. 2:Start removing the air box by the clips on top and removing the filter element. (clean any large debris out so they do not fall into your inlet before removal.) 3:Remove Breather and unclip the tube from the airbox that goes over the breather inlet: 3:Loosen Screw Clamps on front and back using a bit driver. (the clamps are 1/4" so no bit need be installed in the bit driver.) 4:Remove rubber cable holds near back of airbox then lift to remove air box: 5:Insert 2.25' - 3' into intake tubing and tighten using bit driver. (confirm they are tight and do not move.) 6:Attach filters and clamp down using Flathead screwdriver. 7: Enjoy!! Last edited by 535XrayIndigo; 06-20-2018 at 05:49 PM.. |
Bookmarks |
|
|