|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
ABS pump re-programming?
|
|
03-21-2021, 09:17 AM | #1 |
Enlisted Member
3
Rep 44
Posts |
ABS pump re-programming?
Hi!
I bought ABS pump that comes from 320d 177ps E91. My current car is 2.5l petrol 218ps E91. I want to be sure if the pump is compatible hardware-wise. Initially, I thought that I would just change the plastic module so I don't need to re-program. Then I realized they are different modules. I couldn't take the plastic module out of the ABS module. Now my question is if they are compatible. If yes, what kind of software is required to program? Thanks in advance! |
03-21-2021, 12:41 PM | #2 |
Enlisted Member
3
Rep 44
Posts |
I have changed the abs module anyway. Remaining things to do are brake bleed and programming.
I google about software and get more confused the more I read. I have D-Kcan and Inpa. I read it requires Ether cable and Icom or either way. I'm downloading ISTA-D and I continue googling. |
Appreciate
0
|
04-04-2021, 10:38 AM | #3 |
Enlisted Member
9
Rep 30
Posts |
It is well known that if your car is six cylinder you need a DSC off a six cylinder. Depending on what fault codes you get from INPA, you may be able to fit your current controller to a replacement hydraulic block. Therefore not needing to code or programme.
david |
Appreciate
1
tomasis3.00 |
05-06-2021, 04:40 PM | #4 |
Enlisted Member
3
Rep 44
Posts |
I had a lot of trouble with programming.
I go back to the start of the route I look around for a similar module so I can just change DSC module. I will check if I can transfer the ABS pump components from the Diesel one though. I wonder if the components are identical like in the second picture. I don't need to go over carbon brushes or bearing. |
Appreciate
0
|
Bookmarks |
|
|