[topproff]

Good afternoon all,

Unfortunately during an ISTA D & DCAN silver cable fault code delete on my 2007 E92 330D, the laptop i use for diagnostics died.

This has now caused all modules in the control unit tree to become red and unresponsive.

The new 21 fault codes all show 'yes' in existent and a milage of -1.

It must be because the laptop switched off during the communication to the ECU.

Has anyone experienced this?

Any help from ISTA gurus would be greatly appretiated.

Many thanks, Matt.

[MrSweet1991]

Originally Posted by topproff

Good afternoon all,

Unfortunately during an ISTA D & DCAN silver cable fault code delete on my 2007 E92 330D, the laptop i use for diagnostics died.

This has now caused all modules in the control unit tree to become red and unresponsive.

The new 21 fault codes all show 'yes' in existent and a milage of -1.

It must be because the laptop switched off during the communication to the ECU.

Has anyone experienced this?

Any help from ISTA gurus would be greatly appretiated.

Many thanks, Matt.

How long have you had and used that cable? Reason I ask is, if all of those modules where in fact unresponsive then the car would be completely dead. If the car runs and seems fine then its likely the cable, to double check you could fire up INPA which is free from bimmergeeks and see if the cable and ignition is detected and then try to pull some codes. If its not showing any life again I would say cable.

[ccfj1]

Tend to agree, I would look at getting a new lead, pref the EdiabasLib firmware modded version (so you dont get the small packet problems).

ecuworx do them

https://www.ecuworx.co.uk/category/tuning-tools/