|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
320d Manual gearbox problem doesn't going in to 1st
|
|
01-10-2012, 04:04 PM | #1 |
OBD Port Disabled
81
Rep 617
Posts |
320d Manual gearbox problem doesn't going in to 1st
Hi there guys and girls got 2010 320d the problem am having is once i try putting the car in to 1st gear it pop back out and makes a loud nosie and I am putting my foot on the clutch right down. And sometimes it goes in to 1st with no problem.
The gear box does seem a bit Stiff at times. Any one else having this sort of problem? Do you guys know what it could be and how can I fix it. Can any one help please Cheers
__________________
E90 LCI M SPORT BUSINESS EDITION - STAY SAFE & HAPPY MOTORING |
01-10-2012, 04:26 PM | #2 |
LSD - No, you're not seeing things
72
Rep 3,302
Posts |
Can you get all other gears engaged whilst stationary?
If yes, then you will need the box stripped unfortunately. If no, it might be the clutch not disengaging fully, thrust bearing or fork issue which is still expensive but less so.
__________________
|
Appreciate
0
|
01-10-2012, 04:33 PM | #3 |
OBD Port Disabled
81
Rep 617
Posts |
Yeah all the other gears are fine mate, as it doesn't going in to 1st I have to put in other gear then it will going to 1st
Thanks for the help means a lot top man
__________________
E90 LCI M SPORT BUSINESS EDITION - STAY SAFE & HAPPY MOTORING |
Appreciate
0
|
01-10-2012, 04:39 PM | #4 |
LSD - No, you're not seeing things
72
Rep 3,302
Posts |
Sounds like a synchromesh fault to me, possibly a selector fork but most likely the syncro.
Try engaging it with engine stopped. If its reliably okay then syncomesh parts damaged. If still troublesome, probably the selector fork. Either way these are inside the gearbox. Unfortunately you need to strip that box down so its quite a big job Steve
__________________
|
Appreciate
0
|
01-10-2012, 05:01 PM | #5 |
OBD Port Disabled
81
Rep 617
Posts |
Cheers dude I will take it to the dealer first and see what they say. Normally they don't like spending there time or money they blame it on the driver see what they say as it's under warranty and it's a cat d.
Say I come up to a traffic light and as it's got the auto stop start it turn off, I turn it back on and dont going and there's cars behind me and am messing around trying to put it in gear haha. I will most probably have to open and sort it or I will just have to get other gearbox. Cheers mate really appreciate your help, your a top dude you know your stuff, once again thanks
__________________
E90 LCI M SPORT BUSINESS EDITION - STAY SAFE & HAPPY MOTORING |
Appreciate
0
|
01-11-2012, 04:16 AM | #6 |
Private First Class
12
Rep 126
Posts |
I have this problems with my 320d. i used to have to select 6th then 4th then 2nd then it would go into 1st Lol
But did a bit of research and it seems to be a reasonably common problem. found out that if you rev the car abit you can also select 1st (handy at the lights when it wont go in!) havent been able to find out what exactly causes it though? trouble with sourcing another box is you never know if it has the same issue? (unless you get a new one of course which would be silly money) If you get the box removed a specialist shouldnt charge much more then 200 to rebuild with a few new syncros. (my local specialist charged me 165 to rebuild a quaife box in the past) |
Appreciate
0
|
01-11-2012, 04:18 AM | #7 |
Major General
1440
Rep 8,167
Posts |
It's a 2010 car under warranty - just take it to the dealer and get them to sort it, surely?
__________________
Ian
Current: 2021 G21 330i M-Sport Previous: 2018 A6 Avant S-Line MMI+, 2014 F31 320d M-Sport, 2013 F10 520d M-Sport, 2011 F10 530d M-Sport, 2008 320i M-Sport Coupe, 2002 325i, 2001 318i valvetronic, 1998 318i, 1996 525i, 1990 Porsche 944S2 |
Appreciate
0
|
01-11-2012, 05:10 AM | #8 |
Brigadier General
114
Rep 3,866
Posts |
|
Appreciate
0
|
01-11-2012, 02:11 PM | #9 |
Private First Class
12
Rep 126
Posts |
oh right. Forget that! Lol
when i had my box rebuilt last time the place i took it to was the place that bmw/mercedes and other companies locally send all their boxes too anyway as well. Would imagine if i had gone through them for the same job price would have been like 3 - 4 times as much! |
Appreciate
0
|
01-11-2012, 03:35 PM | #10 |
Private
1
Rep 70
Posts |
gearbox
I have 116,000 on the clock and my gearbox struggles to go in first some times. It has done it since i got it at 100,000, i have changed the oil in the box and didnt make a difference.
I wouldnt worry to much. |
Appreciate
0
|
01-11-2012, 05:13 PM | #11 | |
LSD - No, you're not seeing things
72
Rep 3,302
Posts |
Quote:
Same as the OP I suspect. By running down the box you are spining up all the various layshafts inside and matching rpms a bit better. Turn the Stop Start off completely on the dash button would be my advice if he's getting stck at the lights... I had a mini with a knackered clutch slave and had to rev match (doube declutch) to go down the box. This is where you select neutral, lift off the clutch, rev the engine and then clutch back down and jam into the next lower gear. Get it right and its quite smooth actually, and if the syncromesh has failed this will work for you too... However, I wanted fourth to third as approaching a roundabout. Rev matched and got into a lower gear okay, and bang - and the gearshift goes limp in hand. Managed to get first insead of third at about 25mph and the engine whipped so hard that the gearbox remote arm sheared clean off at the gearbox
__________________
|
|
Appreciate
0
|
01-11-2012, 06:07 PM | #12 | |
Private First Class
12
Rep 126
Posts |
Quote:
|
|
Appreciate
0
|
01-11-2012, 06:42 PM | #13 | |
OBD Port Disabled
81
Rep 617
Posts |
Quote:
When to the dealer said it's my fault he said I don't put my foot all way down lol. I put my foot down all the way but it's working fine right now touch wood.
__________________
E90 LCI M SPORT BUSINESS EDITION - STAY SAFE & HAPPY MOTORING |
|
Appreciate
0
|
01-11-2012, 06:48 PM | #14 | |
OBD Port Disabled
81
Rep 617
Posts |
Quote:
They always try to blame the driver not just BMW all the other companies do to and the BMW in Birmingham city centre are not the best with there custormer service. Don't get me wrong there is a few that are awesome and really helpfull.
__________________
E90 LCI M SPORT BUSINESS EDITION - STAY SAFE & HAPPY MOTORING |
|
Appreciate
0
|
01-11-2012, 06:52 PM | #15 |
OBD Port Disabled
81
Rep 617
Posts |
The reason why this happens is because you don't put your foot right the way down on the clutch. That's what the dealer said. Lol
__________________
E90 LCI M SPORT BUSINESS EDITION - STAY SAFE & HAPPY MOTORING |
Appreciate
0
|
01-12-2012, 12:34 PM | #16 |
Enlisted Member
3
Rep 31
Posts |
Exact same problem with my car, i only do a short distance to work and its a pain in the arse.
When the gear stick is stuck near first i rev the engine and it slides in no problem. So do you reckon it would cost much to fix the box? Couple of hundred? |
Appreciate
0
|
01-12-2012, 04:04 PM | #17 |
Private
1
Rep 70
Posts |
the job could snow ball if you opened it up and end up costing you a fortune, you never know what else could be worn if you opened it up. I wouldnt like to guess at prices it would give me nightmares lol
I would say mine is a little notchy going in first but has never got stuck, just a bit stiff. Maybe an oil change would help, bmw say they are sealed for life units but they give us a drain and fill plug on the gear box. My local dealer would of done it for me but wanted a fortune to do it so i did it myself. |
Appreciate
0
|
01-12-2012, 04:16 PM | #18 |
LSD - No, you're not seeing things
72
Rep 3,302
Posts |
+1
Its labour cost to remove and replace that tops it up a fair bit. And whilst out you would be crazy to not consider the clutch/RB/flywheel maintenance. Won't get much change from £600 for the box work alone is my guess.
__________________
|
Appreciate
0
|
11-04-2012, 10:26 PM | #19 | |
Registered
0
Rep 3
Posts |
same problem
Quote:
I have the similar problem, it happen rarely for beging and make me think it may be my opeartion problem, but it happened more frequently. I think it may bacause the wear everytime it happen. It is the mechanical problem of synchromesh gear. Finally, you have to replace the gearbox, go to your dealer. ***** sorry, my problem is when when i shift to 1st gear and start to move, the shift will pop back to neutral position with a loud noise!! Last edited by tnaflyer; 11-05-2012 at 10:09 PM.. |
|
Appreciate
0
|
Bookmarks |
|
|