View Single Post
      12-03-2012, 05:24 PM   #29
shiv@vishnu
Tuner
 
Drives: X1, 335i
Join Date: Sep 2006
Location: SF Bay, CA

Posts: 17,616
iTrader: (0)

Quote:
Originally Posted by BigBoosting View Post
Is there a simple step I am missing when changing the AFR table values? I changed each cell one by one to 50, then reset the Procede, turned the car off, waited a few seconds, and then started the car back up. OL is set at 60 with trims hovering around 24%.

I then did a few logs and the AFR's are identical to what I was seeing before I touched the AFR target table.
That's it. Just set AFR target table to 50 and then adjust (lower) open loop fuel value from there until you fuel trims are reasonable. I still like to see them positive (10-20% is good). If you don't lower the open loop fuel value, they will be negative which will make the car feel a bit sluggish since it will run rich during transient load conditions (before the DME has a chance to pull out fuel).

Shiv
shiv@vishnu is offline   United_States
0
Reply With Quote