|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
PROcede v4 User software Wish List
|
|
02-25-2010, 03:53 PM | #1 |
Colonel
324
Rep 2,663
Posts
Drives: BMW 335xi Sedan; BMW M3 ZCP
Join Date: Nov 2007
Location: NYC
|
PROcede v4|v5 / User software Wish List
Just started this tread because some of us post these things in different places. Lets keep it clean & all in one thread.
These are currently working: - 6AT Launch control______________________Launch an 6-speed automatic car - Adjustable CANClear - on/off______________Enable & Disable CANClear feature - Ajdustable Audible Shift Alert/Light_________Adjustable from 5000 to 8000rpm. The shift light function is delivered by your in-dash turn signal lights. Beeps on non IDrive models. - Auto-Tune logging parameter______________Logs Ign Correction, Boost, Meth Flow, IAT - CANclear functionality____________________Clear tuner codes automatically - Command Center________________________There is no laptop required to use it! You can calibrate your in-dash gauges, select your shift-light RPM, reset several adaptions and much more. - Diagnostic tool__________________________Built-in/integrated Diagnostic tool for code reading/clearing - DIC (Dynamic Ignition Correction)___________Is to ensure that the Procede's ignition correction offsets works in complement with the DME's conditional short-term timing reduction schemes - Dual-Bank Wideband AFR__________________Monitors and logs functionality of the Air/Fuel Ratio - IN-DASH boost gauge____________________Display Boost pressure on your dashboard - Map Display____________________________Temporarily revert back to stock gas level/oil temp gauge display mode by simply requesting a current map display(cruise control stalk bumped up) - More Available Channels for Data Logging____More Channels to data-log with - Multiple map selection____________________Press DTC to change maps - Naturally Aspirated (NA) Mode_____________Car runs without use of the turbo's - Netbook friendly_________________________Netbook compatibility software - Persistent aggression level________________It does not reset to 0 after you turn off/on your car - Persistent mapswitching__________________The Procede will now start up on the last map selected before engine shut off - Progressive methanol mapping_____________ - Rename "Lag Fix" parameters_______________It's been renamed to "Barometric Offset" - Resetting adaptations through CanBus_______Diagnostic Adaptation Resets (i.e - Throttle, Lamba, AFR, Battery, Knock, Octane, Vanos, VVT, 6AT Trans, Airbag, TPMS) - V5 Autotuning (Ignition correction)__________Adjusts Ignition Correction automatically - V5 Autotuning (Boost)____________________Adjusts Boost automatically - V5 Autotuning (Progressive Methanol)_______When meth is flowing above the threshold, the Procede's autotuning system is active - V5 Autotuning (Wastegate Compensation)____Means that boost will rise as quickly as you put your foot down - Valet Map not indicate during startup________Valet Map doesn't blink during startup of engine (Great for dealership drop-offs) Users want: - Ajdustable Audible Shift Alert for IDrive model (Navigation) (In Development) - Adjustable oil temp protection - Some climates takes longer to warm up - Autotune + Progressive Nitrous (In Development) - Change gauge colors in user software - Command Center control while driving - Default filename in HH:MM M/D/Y format instead of every data log defaulting to data1 when saving - DTC enabled or disabled (software option) - So is stays persistent or we have it start like the speed limiter On(1)/Off(0) - Keyfob specific map - Car starts up on the desire map with each remote keyfob (I have keyfob 1 to start Map2, Wife keyfob 2 to start Map 0) - Mac friendly or java based to work on multiple platforms - Max cool mode - More gauges to display on-screen - Needles on the gauges a little longer on the user software(Closer to the numbers) - No-boost valet map + Throttle cut off (50% max) + Rev limit (>3500RPM) - Real-time instantaneous data display in graph - RPM guage max to 8000 RPM on the user software(Have more space to see 1K, 2K, through 8K) - Software to read DME codes with description - Specific Speed Limit Setting - Valet speed limiter Last edited by AltecBX; 03-25-2011 at 09:15 AM.. |
02-25-2010, 04:16 PM | #2 |
Colonel
102
Rep 2,760
Posts |
Valet speed / Rev limiter.
__________________
E92 335 | Space Gray | Saddle Brown Dakota | Dark Burl Trim | ZPP | ZSP | AT | Idrive | 6FL | FBO | Dinan CAI | Quaife LSD | STG3 PROCede.
|
Appreciate
0
|
02-25-2010, 04:48 PM | #4 |
Major
69
Rep 1,137
Posts |
palm interface or iphone interface
__________________
2008 335i coupe AW 6AT, RB Turbos, PROcede 2.5 V5, Alpina Flash, Injen Intake, VK MW DP . Helix IC, Vishnu PnP Meth(M10 nozzel), M3 sides, OEM Aero Lip, VMR V710 Midnight Blue, LUX H8, HID Fogs, M3 front bits, D2 Coilovers, Whiteline Rear Bushing inserts, Custom M3 Steering Wheel, Cyba scoops, M2 Performance Exhaust |
Appreciate
0
|
02-25-2010, 04:52 PM | #6 |
I don't drive fast , i fly very low
14
Rep 358
Posts |
European Dash map switching indicator fix,
European cars ( basically NON US cars ) still now showing anything on the dashboard when changing maps ,, DTC works fine for changing between maps ..but the indicator is not functioning . |
Appreciate
0
|
02-26-2010, 12:32 AM | #7 |
Brigadier General
394
Rep 3,161
Posts |
+1
__________________
2015 M3 BPM Tuned, Eibach, Magnaflow and more www.tmrmzine.com/m3/f80
SOLD E92 Slēk Carbon Fiber Widebody M3 www.tmrmzine.com/m3/slek/ SOLD E92 335i Stage 3+ with all the toys www.tmrmzine.com/335/ SOLD E39 M5 Modded, What a great car! www.tmrmzine.com/m5/ |
Appreciate
0
|
02-26-2010, 01:23 AM | #8 |
Private First Class
20
Rep 168
Posts |
This is not true, i have a EU Version and i see the engine light as the map indicator!
__________________
STOCK
|
Appreciate
0
|
02-26-2010, 01:31 AM | #9 | |
I don't drive fast , i fly very low
14
Rep 358
Posts |
Quote:
BMW has 2 version , US version which is for USA ,, EU version which goes all around the world .. so you can't compare your car to the cars goes to Russia - or Middle east or even to South Africa ... read this thread specially Post # 27 , not only me who has this issue ,, a lot of people has it too .. http://www.e90post.com/forums/showthread.php?t=330764 anyway , thank you for your comment ,, and you are lucky if it's works fine with you .. |
|
Appreciate
0
|
02-26-2010, 02:01 AM | #10 |
Major
58
Rep 1,230
Posts |
Map indication works well for me and I'm in Australia..............no where near the US.
Not sure what the issue is with certain areas so I'm guessing maybe Australia gets similar setup as US. |
Appreciate
0
|
02-26-2010, 02:37 AM | #12 |
I don't drive fast , i fly very low
14
Rep 358
Posts |
funny how in Europe itself ,, several guys in Germany and Holland reported the same issue .. you are in Zurich and you don't have this problem .
I've tested the Procede on several cars here in Dubai , they all had the same issue ,, and that was the main reason most of the guys here don't buy vishnu and they go for a famous tuner here in middle east called Vizu , it's shit comparing to vishnu but they have the map switch controller which shows the maps and some other useless info ... I've emailed Shiv about this that he has to look after this problem seriously ..but unfortunately he never answered me ... I was thinking of doing some business with Shiv for the vishnu reseller here in Dubai .. but i can't sell something which has missing option comparing to the features announced on Shiv website ... let's see what will happen then .. |
Appreciate
0
|
02-26-2010, 02:46 AM | #13 |
1737
Rep 17,960
Posts
Drives: A Lot
Join Date: Sep 2006
Location: SF Bay, CA
iTrader: (0)
Garage List 2018 Ducati Panigal ... [0.00]
2016 Mazda CX5 [0.00] 2017 Aprilia Tuono ... [0.00] 2019 BMW M2 Competi ... [0.00] 2015 BMW M5 Competi ... [10.00] 2016 Ducati XDiavel S [0.00] 2016 AMG GT S [0.00] 2011 Ferrari 458 It ... [0.00] 2017 Charger Hellcat [0.00] 2015 KTM Super Duke ... [0.00] 2016 KTM RC390 [0.00] |
Honestly, It's really hard for use to do things for certain non-NA cars that are equipped differently. In this case, there are cars in the world that don't have functional SES lights. When we get caught up with things, we can look into possible solutions (like getting other lights to flash and indicate map selection). But right now, we are focused with finishing v4.
Shiv |
Appreciate
0
|
02-26-2010, 02:50 AM | #14 |
Major
58
Rep 1,230
Posts |
That's a shame, since this problem you are experiencing seems to be region specific in only some areas around the world and not all non-US countries as you assumed.
Last edited by Sparky66; 02-26-2010 at 02:55 AM.. |
Appreciate
0
|
02-26-2010, 02:53 AM | #15 | |
I don't drive fast , i fly very low
14
Rep 358
Posts |
Quote:
Hope you have a free time soon to look after this as well as the other wish list of the other members here ... |
|
Appreciate
0
|
02-26-2010, 03:48 AM | #17 |
Major
58
Rep 1,230
Posts |
My wishlist:
1.) When the car is started in "Valet Mode", remove the Valet map mode SES indication, so the dealer doesn't see any strange elongated SES light.....but if you then toggle through the maps via the DTC buttton, then SES light should indicate Valet Mode. With that being said, if you start your car in map1 or map2 it should always indicate which map you are in via the SES light. 2.) Now that progressive meth map is switched via an output on the Procede and moved away from the expansion port..........can we please re-enable map switching via Rixeffect's Vent Boost Gauge for those that still would like to use their gauge to switch maps. 3.) Procede User Software can only log 10 parameters at a time.........why is that? Bandwidth issues?? 4.) Rename the confusing "Lag Fix" parameter in the User Adjustables to "Barometric Pressure Compensation" as some people are inadvertantly enabling it, thinking that it globally "fixes lag issues". |
Appreciate
0
|
02-26-2010, 03:59 AM | #18 |
Private
1
Rep 59
Posts |
No problem's here with "Euro-car"...my wish is to have scrollable user-adjustable menu since I use mini-laptop in my car with 10" display and the OK button is "invisible", outside the display area...
__________________
Vishnu-Quaife-AR-Helix-BMS-Stett-Tial-McKinney
|
Appreciate
0
|
02-26-2010, 04:27 AM | #19 |
Captain
38
Rep 944
Posts |
eliminate 02 sim, would be enough for me at all.
__________________
http://www.youtube.com/user/Ferre86
| e93 M-DCT ESS VT2-625 | Akra Slip-on | Challenge Race Catless x-pipe | Challenge front lip | Challenge Diffuser | Carbon front grilles | defi gauges control unit | Macht Schnell gauge panel | E93 M3 trunk Spoiler | IND Carbon Fiber Side Markers | |
Appreciate
0
|
02-26-2010, 04:45 AM | #20 | |
I don't drive fast , i fly very low
14
Rep 358
Posts |
Quote:
hahaha ,, i do have the same problem ,,be honest with you ..it's the 10" laptop problem not the user software ... |
|
Appreciate
0
|
02-26-2010, 09:42 AM | #21 |
Colonel
102
Rep 2,760
Posts |
I am assuming they used VB for the internet. Easy fix, turn it into a web page. Also in Java easy fix turn same into a webpage you don't have to scroll nothing as browser will do that for you. And that will work well with all form factors.
__________________
E92 335 | Space Gray | Saddle Brown Dakota | Dark Burl Trim | ZPP | ZSP | AT | Idrive | 6FL | FBO | Dinan CAI | Quaife LSD | STG3 PROCede.
|
Appreciate
0
|
02-26-2010, 10:45 AM | #22 |
Captain
73
Rep 978
Posts |
|
Appreciate
0
|
Bookmarks |
|
|