|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Official Dynavin BMW E9X Review, Pics, Questions, etc.
|
|
03-13-2011, 09:39 PM | #287 |
Major
79
Rep 1,369
Posts |
|
Appreciate
0
|
03-13-2011, 10:32 PM | #288 |
Lieutenant General
1988
Rep 13,280
Posts |
Logic 7 uses a fiberoptic connection to the amp
http://www.e90post.com/forums/attach...1&d=1209780605
The dynavin uses a common analog connection Head Unit out amplification of the type found in most Head Units. The BMW l7 amp will only accept fiberoptic signals from the BMW Head Unit If you want to replace the BMW amp you could do it but you would have to run new wiring to the trunk ,install new amps and figure out an amping scheme for the speakers. |
Appreciate
0
|
03-15-2011, 07:43 PM | #289 |
240
Rep 3,155
Posts |
Hey guys,
Is it too late to get a deal on this unit??? Anyone know? Or should i just try and contact them direct. I just read all 14 pages, but I see no indication of how one is supposed to know if they have Logic7....i'm new, and just bought a 2007 BMW 328i coupe...any insight on the matter would be greatly appreciated. |
Appreciate
0
|
03-15-2011, 09:47 PM | #290 |
Lieutenant General
1988
Rep 13,280
Posts |
FYI
http://www.e90post.com/forums/attach...2&d=1266451970
There are three systems world wide that are documented and another called the Dirac or personal audio that I haven't seen documentation on . The base system or stereo system only made it to the US in 2010 2011 but has been distributed in other countries for I don't know how long. It has no tweeters in the front door sills next to the rear view mirrors. the other two common systems Hi Fi and L7 have tweeters in the door sills and either in the rear doors or deck, http://www.e90post.com/forums/showthread.php?t=407085 The way to tell the HI Fi from logic 7 is is it logic 7 has a center speaker in the dash and the radio has an equalizer rather than simple bass and treble controls. |
Appreciate
0
|
03-16-2011, 09:53 PM | #291 | |
240
Rep 3,155
Posts |
Quote:
Seems like I got the logic 7 version, so this system is not an option for me. Too bad |
|
Appreciate
0
|
03-17-2011, 11:54 AM | #292 |
Private First Class
5
Rep 149
Posts |
I finally connected the Dynavin HU directly to my JL XD600/6 with separtate RCA cables. The quality and sound performance is much better than it was using harness outputs. Before reqiring I could only turn the HU up to about 6 out of 40 because of the amplified output signal feeding my amp.
Now I can comfortably turn it up to 20. Front and rear amp gains set to zero, subs (SWS-8 2ohm) running about 50% gain. Amp X-overs set at about 150HZ. Before rewiring I experienced a loud hissing noise when using any HU bass or treble. It's completely gone now. I have a coupe and ran the wires under the lip of the center console trim on the passenger side. I popped up the rear passenger seat and ran the wires under the rear center console and into the trunk. Should have taken less than 1 hour, but of course ended up being about 3 by the time i was finished tweaking everything. For anyone who has the Dynavin HU and plans to pull it out of the dash for any reason, be aware that it might not come out like it went in. The metal clips that screw into the assembly below climate control are designed to engage against a lip that sticks up in the lower part of the HU location. There is no way to pull straight out. Carefully pull the upper part of the HU back using a small diameter metal hook. Once pulled away enough to grasp with fingers continue to gentle pull back and up. This motion will foce the metal clips to bend enough to allow the HU to slip up and over the trapping edge. Before reinstalling the HU I removed the clips and actually bent the parts that lock in so that they won't lock. The unit compresses inside the dash enough without needing the clips to lock in place. My HU is defective and is going to be replaced with a new one within the next coupld weeks - I didn't want to go through the awful removal process again. |
Appreciate
0
|
03-17-2011, 12:06 PM | #293 |
Private First Class
5
Rep 149
Posts |
Another update - I tried the Bluetooth music streaming using a Droid2 phone. Sound quality and frequency range was impressive. The only dissapointment was that when toggling to Navi mode the music cuts out. When connected to a call the Navi mode works without dropping call. I think it happens with streaming music becuase the system is not in a call - it is basically in stand-by mode when not in calls. It's in this stand-by mode while streaming music.
|
Appreciate
0
|
03-17-2011, 02:14 PM | #294 | |
Private First Class
3
Rep 121
Posts |
Quote:
The gain knob allows the amplifier to connect to different pre-amplifiers that may have varied output line levels. Your amp likely has voltage values written around the knob. Perhaps something in the millivolt range up to whole volt numbers. (100mV to 2V, or something like that). That voltage should match, likely at 1kHz, the voltage present on the RCA cables. Realistically the average end user will not understand nor have the ability to measure voltage on the RCAs. My point in explaining this is that perhaps you shouldn't have the gain "all the way down". You might be doing yourself a disservice. Of course I don't know what speakers you have, the may be really sensitive and as such require the amp to be down. |
|
Appreciate
0
|
03-17-2011, 03:41 PM | #295 | |
Private First Class
5
Rep 149
Posts |
Quote:
|
|
Appreciate
0
|
03-17-2011, 05:23 PM | #296 | |
Major
79
Rep 1,369
Posts |
Quote:
I have it and im confused about getting this HU. Thanks for any help |
|
Appreciate
0
|
03-17-2011, 05:42 PM | #297 | |
Captain
216
Rep 633
Posts |
Quote:
You can use this in a car with L7, it's just not an easy undertaking. Your biggest hurdles are: a. You will need to keep the OEM head unit tucked away in the car. b. Your factory L7 amp will not work. You will need to power the factory speakers from the Dynavin unit and/or additional amplifiers. Your L7 system has 14 individual drivers, powered by nine independent channels. The Dynavin headunit has only 4-channels of power. Do you want to add additional amplifiers, give up some speakers or a combination of both? |
|
Appreciate
0
|
03-17-2011, 08:18 PM | #298 | |
Major
79
Rep 1,369
Posts |
Quote:
So why the guys at jlevi tell me its a plug and play? |
|
Appreciate
0
|
03-18-2011, 09:21 AM | #300 |
Major
79
Rep 1,369
Posts |
But I told them that I do have L7 and they still say it's plug and play
__________________
|
Appreciate
0
|
03-18-2011, 09:55 AM | #301 | ||
pull my finger to get your kinder® surprise
148
Rep 10,455
Posts |
Quote:
Here's biz77's response to you a few posts up. Quote:
__________________
|
||
Appreciate
0
|
03-18-2011, 11:54 AM | #302 | |
Major
79
Rep 1,369
Posts |
Quote:
Like i said Im looking for plug and play and what he says seems a bit complicated. I might as well just leave it alone |
|
Appreciate
0
|
03-18-2011, 02:30 PM | #305 |
Major General
118
Rep 5,177
Posts |
__________________
|
Appreciate
0
|
03-18-2011, 03:04 PM | #306 |
Major
79
Rep 1,369
Posts |
|
Appreciate
0
|
03-18-2011, 03:57 PM | #307 |
Brigadier General
294
Rep 3,201
Posts |
|
Appreciate
0
|
03-18-2011, 05:14 PM | #308 | |
Private First Class
11
Rep 134
Posts |
Quote:
2. Aside from losing BMW Assist, Bluetooth, and Chimes, do I lose anything else by removing OEM HU? (I don't want to relocate HU.) 3. Do all the steering wheel buttons work, particularly with ipod/iphone? 4. Artwork shown with ipod/iphone on Dynavin? Right now I really like my Voice Commands, and how my iphone connects via USB flawlessly into the HU (i.e. displays playlists, steering wheel controls, etc). Thanks all!
__________________
11 E90 323i 6MT • AW|Black|Satin • BMW Performance Grill • F1 Pinnacle 30 • |Coded: M3 Digital Speedometer • Corner Light Del • AE-DRL | • Mtec H7 • Mtec H8 • RDash AE LED V2 • M3 Lip Spoiler • BMW SSK • Gloss Black Roof
|
|
Appreciate
0
|
Bookmarks |
|
|